0 Best Practice Guide Pesticide Handling Areas. Before Spraying:

Best Practice Guide Pesticide Handling Areas. Before Spraying:

Why Pesticide Handling Areas are Important:

At least 40% of surface water pollution by pesticides may come from the pesticide handling areas. Water is vulnerable from tiny splashes and spills that occur when filling the sprayer and when rinsing the container. Inappropriate wash down, cleaning and disposal activities can also have significant adverse environmental impact. Just one dropped foil seal can contain enough pesticide to contaminate 30 km of stream. In one study it was possible to reduce the pesticide contamination coming from the handling area by 99%. A key step to achieving this change was to review the site and the surface used for filling and wash down activities.

Pesticide users and sprayer operators must therefore not only look carefully at the design and surfaces used in the handling area, but also their own practices so that we can do more to protect water from accidental pesticide contamination.

Reviewing the Site:

Siting and design of pesticide handling areas has developed over the years for operational convenience rather than pollution control. New research has shown that the concrete filling area, so typical of many pesticide handling areas, is potentially the worst surface for handling pesticides; things can be made even worse when the water from the concrete pad drains into a local ditch.

Changing the site, its layout and surface to improve the management of waste liquid and run-off can show reductions in pesticide load of 1000-100,000 fold. Under the Voluntary Initiative, all pesticide users and spray operators are being encouraged to review their current sites and to consider solutions and practices which can prevent, control, retain and degrade pesticide residues and significantly reduce pesticide pollution of water.

Planning Ahead:

Before making any changes to your existing arrangements you should consider carefully two factors:

1. Local Water Priorities:

Establish if and how local water sources may be affected by what you do at your handling area. Advice and information on water quality risks is available from your local office of the environment agency. They can also advise you if you are in a Groundwater Protection Zone as well as giving you background information on local hydro-geology. In any event, you should ensure that the pesticide handling area is sited:

  • At least 10m away from any watercourse or vulnerable site;

  • At least 50m away from any borehole spring or well;

  • Away from existing farmyard flash flood routes, rain water outlets and gutter outfalls;

  • Away from farmyard drains and not above any tile or mole drains;

  • Aside from main business traffic routes ;

  • On well structured soil with at least 1.6m depth of soil and sub-soil before bedrock;

Ensure as far as practical that any pesticide contaminated water is handled separately from other drainage water. Use a bund (low concrete lip) to keep the handling area water within the area and to keep rain water and other vehicles out of the filling area.

2. Handling Area Purpose:

Any handling area should allow the operator to work safely and efficiently, but it is also important that the area contains any contamination. Thus the handling area should collect all drips and splashes and run-off from rainfall. (Note: Any significant spillages should be soaked up and removed for separate disposal). However, the key decision is whether the handling area will be used just for sprayer filling or whether wash- down activities will also take place. If the sprayer is being washed down it will:

  • Increase the amount of waste liquid This means that for some solutions a larger disposal area may be required.

  • Require a Groundwater Authorisation (GWA) All cleaning and wash down operations that do not take place "in the crop" are regarded by environment agencies as "disposal". This means that you require a GWA from your local environment agency.

There is a one-off application fee (currently £103) in England/Wales in Scotland there is an application fee (£162) and annual subsistence fee (£132.70). (Note any changes to an existing GWA, such as introducing a Biobed, need to be advised to the local environment agency).

Pesticide Handling Area Solutions:

Overleaf this guide looks at six different solutions all of which have the potential to significantly reduce water contamination when installed and used correctly. All of these solutions are likely to offer an improvement over an ordinary unmanaged concrete pad. A portable bunded area can help trap spills. The use of either a grass/soil area or a biobed can ensure that any pesticides are trapped in a chemically and biologically active area. This means that over time they can be degraded by the processes in the soil or biobed.

Portable Bund:

A portable bund with a suitable lip and made from non-absorbent material can be used to trap spills and splashes. The bund can be washed down and then drained back into the sprayer for application to the "crop" or treated area.

Advantages/ Disadvantages:

  • Cheap Not suitable for washdown.

  • Simple Bund not proven with sulfonyl ureas.

  • Easy clean up of larger spills Bunded area may get contaminated with soil

Grass & Soil:

Move handling area to grass reinforced with a grid or gravel. This is only suitable for filling, mixing and sprayer maintenance. Periodic movement of the area selected is advised. Note: Do not remove top soil when installing grid; a thin layer of gravel may be placed above the top soil to improve surface stability. Not recommended for heavy clay soils due to compaction risks.

Advantages /Disadvantages:

  • Cheap May not be convenient for services and sprayer storage.

  • Easy to establish Not suitable for wash down.

  • Grass/soil will become compacted over time.

  • Not suited for some soil types - awkward to walk on when churned up

Offset Grass/Soil Disposal Area:

Drain handling area to a grass/soil area; the handling area will need to be drained to a sump the liquid from which can then be trickle-irrigated on to a grass/soil surface. This system is suitable for filling, mixing and sprayer wash down.

Advantages/ Disadvantages:

  • Low cost GWA from local environment agency for wash down.

  • Suitable for both handling and wash down Limited capacity.

  • Sump drainage/trickle irrigation will require management

Offset Biobed:

Drain handling area to a biobed; the handling area will need to be drained to a biobed possibly via a sump. The liquid can then be spread or trickle-irrigated on to the biobed surface. This system is suitable for filling, mixing and sprayer wash down.

Advantages/ Disadvantages:

  • Moderate cost GWA from local environment agency for wash down.

  • Suitable for both handling and wash down Sump drainage/trickle irrigation may require management

Drive Over Biobed:

Biobed* with metal grid and support frame. The liquid drains straight through to biobed. This system is suitable for filling, mixing and sprayer wash down.

Advantages/ Disadvantages:

  • Ease of management GWA from local environment agency for wash down.

  • Suitable for both handling and wash down Major changes may be required to existing handling site.

  • Higher Cost.

Fully Contained System:

Full system with sump and tank for storage of all waste water. Liquid waste collected by a licensed waste disposal contractor or a GWA site. Suitable for filling, mixing and sprayer wash down.

Advantages / Disadvantages:

  • No requirement for a GWA Major changes may be required to existing handling site.

  • Suitable for both handling and wash down High cost to build.

  • Careful management of volumes required.

  • High operating cost

Biobeds:

More information on the design and operation of Biobeds can be found in the Best Practice Guide - Biobeds

The advice in this Guide has been prepared after consultation with the UK environment agencies and leading researchers into pesticide handling areas. Research was funded by defra, EA, CPA and SNIFFER.

This Guide was produced by the Crop Protection Association as part of The Voluntary Initiative. The Voluntary Initiative is a programme of measure agreed by Government to minimise the environmental impact of pesticides.

This article was kindly provided by Amenity org.uk. Please see link for further pesticide related information :- www.amenity.org.uk/

Editorial Enquiries Editorial Enquiries

Contact Kerry Haywood

01952 897416
editorial@pitchcare.com

Customers Advertising

Contact Peter Britton

01952 898516
peter@pitchcare.com

Subscribe Subscribe to the Pitchcare Magazine

You can have each and every copy of the Pitchcare magazine delivered direct to your door for just £30 a year.