Key Tasks for October
All clubs have their own methods of working and renovating their squares. In most cases the level of work will be dictated by what budgets and resources they have available at the time and what they are trying to achieve.
Make sure your machinery is up to the task with regular services. In the main, most club groundsmen are now putting on between 6-10 bags of loam per pitch. It is important not to under or over-dress your tracks. Even in the current economic climate, it is best not to skimp on the amount of loam used. I see too many club tracks that do not perform in terms of pace and bounce because of poor end of season renovation practices.
Generally, it is usually a combination of two factors that, when combined, causes problems - not removing enough thatch or organic material during renovations and spreading insufficient loam down to increase the bulk density of the soil profile.
However, there is a fine line between too much and too little.
Soil Analysis: - If you have not had your soils tested for some time, then do so at the earliest possible chance. Soil tests commonly carried out fall into two categories: Physical and Chemical.
The Physical analysis of soil reveals its texture, the amount of organic matter present, the rate of which the water passes through the soil profiles and the pore spaces within the soil.
The Chemical analysis produces information on soil acidity & alkalinity, the amount of mineral nutrients available for the grass plant to take up and the amount of toxins that may be harmful to the turf.
Scarification: - Scarification is important to remove unwanted vegetation, but also to produce a key for the new loam material to sit in. The level of scarification required will be dependent on how much of a thatch layer you have generated throughout the season. The best way to identify how much you have is by taking a core sample. It will be then a case of going through a vigorous renovation programme, scarifying in at least three directions, finishing in the line of play.
Depending on how much thatch is removed, where necessary, clean off all the thatch debris after each pass. The square can then be over sown using a suitable grass seed mixture; do not be frightened to try out new cultivars. Sowing rates now range between 35-50 g per square metre. In essence, you are aiming to establish new grasses into your square.
Aeration: - The very basics of grass growth has never changed; sunlight, water and air, three factors essential for good grass growth of all plant life. Whilst we have no influence over the quality and hours of sunlight, there is a single management operation that directly influences the availability of the latter two. That is aeration. The purpose of aerating a cricket square is the key to producing the foundation upon which additional treatments can work.
Aeration relieves compaction, assists in top dressing to migrate down the tine holes and improves water percolation through the soil profile. It also helps to create the general environment essential for healthy grass growth. Autumn and winter aeration treatments are beneficial to promoting drier surfaces for further maintenance practices to take place. Solid tining is usually the most common practice but, where saddling is a problem to your ends, then hollow coring over a period of time will help with settlement.
Soil compaction is often the main contributing factor to poor grass growth; the lack of air in the soil profile inhibits many beneficial activities such as water movement and retaining microbial organisms. A programme to decompact the soil is essential, preferably using a pedestrian powered vertical aerator, to re-introduce some porosity into the profile. Solid tine, hollow coring and linear aeration are a number of methods being used to aerate soil profiles.
These operations tend to be carried out on a frequency basis depending on the type and size of the tines being used. However, there are a number of groundsmen who never aerate their cricket squares; they believe that the aeration holes formed can cause a weakness/stress line in the clay profile that could eventually break, causing problems with the pitches. They believe that the clay's ability to shrink and swell provides the necessary voids to promote root growth.
Top Dressing: - It's important not to overdress the square, as you will not only be wasting the precious loam material but you may also be smothering your sward. The last thing you want to be doing is to bury any vegetation, which will lead to future problems. The object of the renovations is revitalize the top growing zone, restore levels and to integrate new material into the soil profile. This will help build up the clay content in your square.
Irrigation should follow as soon as possible to assist in the germination of new seed. By keeping the soil moist, the seed should germinate between 7-10 days weather permitting, a germination sheet will aid this process.
Once the grass has germinated out on the square, you should look to maintain a cutting height between 15-25mm, and continue to brush off the dew in the mornings to keep the sward in a dry and disease free condition
Once you have finished renovating your square, devote some time to the outfield. Outfields are often neglected if not used for any winter sport such as rugby or football.
They do not get much attention in the way of scarifying / harrowing, aeration, topdressing, over seeding and, in some cases, not even being cut through the winter months.
Mowing of the outfield should be undertaken on a regular basis. By maintaining a height of cut between 25-35mm, this will help to encourage a dense sward and reduce disease.
Invest some money on your outfield to restore levels, kill any weeds and aerate where possible. Some clubs even use their pedestrian Groundsman spiker to aerate their outfields.
It may not be too late to get some selective weed killer applied, especially if soil and air temperatures remain favourable. Also apply a winter feed to help keep some colour and stimulate some growth
ideally, when aerating the outfields, penetration should be down to a depth around 200mm to promote deeper rooting and surface drainage. Some groundsmen like to carry out a programme of solid tining, deep slitting or hollow coring, which again increases porosity but can also help redistribute/recycle topsoil which, in turn, helps restore levels.
The frequency of aeration activities will often depend on the resources - money, machinery and time - available. In the main, you should be looking to aerate throughout the winter period on a monthly basis, weather and soil conditions permitting.
The start of October is set to continue as September has ended, somewhat on the wet side. There are some signs, however, that for at least some parts of the UK this may change to a more settled and drier period toward the second half of the month. Whatever the local environmental conditions are at any given time, paying close attention to what happened in previous years with respect to the timing of disease outbreaks, cross referencing that information against the current date, before then checking that against current prevailing weather conditions prior to looking ahead in a bid to see what is just around the corner, are the absolute fundamental basic levels of turf grass pathogen management in 2019 - these all encapsulating fundamentals of an Integrated Pest Management approach.
In the context of Microdochium nivale control, knowing what happened, what’s happening and what’s about to happen is paramount when determining the likelihood of disease expression and the selection and timing of inputs aimed to counteract the onset of disease attack. Say goodbye to the age of the reactive product applier and say hello to the age of the informed tactician.
The second and third aspects, of course, are what factors favour the pathogen and what factors favour the plant. The final factor is what is the effect of the input or action being taken and how will this influence conditions, either towards the pathogen or towards the host (grass plant).
Regulating nitrogen inputs to maintain steady hardy shoot and leaf growth is a priority. Lush growth is more susceptible to attack by fungal pathogens, so slow release nitrogen, either polymer coated or methylene urea in combination with straight urea will give longevity through to the new year. Where conventional fertilisers are chosen, ensure the ammonium value is not above 4 or 5 percent.
A dose of micronutrients is a good idea to ensure the plant has a full menu of essential nutrition.
Iron – the traditional go to option for hardening the plant in the winter. However, there is no evidence to suggest iron plays a role in directly hardening the plant against pathogen attack. Calcium and silicon are the proven elements for this need. Sulphate of iron, in particular, will weaken the cell walls of the leaf due to the acidity; rather, a fully chelated iron with a pH more towards neutral will be far less antagonistic towards cell wall integrity and beneficial leaf dwelling microorganisms.
Carbohydrates - Applications of carbon energy in the form of sugar during the autumn will be beneficial to the plant and soil over winter. The benefit is a more resilient and well-developed plant in the early spring.
Seaweed – maintain seaweed applications during October, but avoid applications at times when environmental conditions favour fungal pathogens. Seaweed will illicit important beneficial defensive and stress responses in the plant and associated microorganisms when applied ahead of disease activity and when conditions favour the disease.
Amino acids – play an important role in abiotic stress tolerance, helping plants to prepare for and cope with autumnal and winter stress events.
Humates – continue applications to maximise nutrient availability and application efficiency as well as providing habitable zones for beneficial bacteria.
- Adequate balance nutrition of all plant essential elements not just NPK
- Minimise stress by raising heights of cut and avoiding activities such as top dressing which weaken and damage leaf integrity
- Look after the soil via regular light aeration
- Reduce periods of leaf blade wetness by removing dews or using dew dispersants (apply only to a dry leaf)
- Monitor disease forecasts via resources such as Syngenta’s Greencast
- Plan, stock, apply beneficial nutrition as part of non-pesticidal disease management
- Take advice on and plan strategic preventative fungicide applications using historic data, live weather forecasts and site specific conditions and protected maintenance operations which may cause abiotic stress.
There are no legal substances which can be applied for the control of worms. Any substance or products which act directly upon worms would never be approved by CRD for authorisation.
The only legal option is modification of the local surface soil environment via acidifying with specifically formulated solutions of ammonium sulphate or the application of straight sulphate
Beware regular applications of sulphate of iron, they may well discourage surface casting activity, but the iron will accumulate in the soil causing long term imbalances and negative effects to plant health throughout rest of the year.
Senor Technical Manager
Basis No R/E/75421FMAT
Keep machinery in good order, clean after use and top up any oil/fuel levels.
Check cutting cylinders are at correct cutting height and are sharp.
Grounds Training was established in 2006 to provide a complete and unique service delivery training courses for the sports turf industry. We are now the go-to provider for on-site, bespoke training for groups. Alongside our renowned turf maintenance which now includes Lantra accredited Online courses. Grounds Training also works with the industry’s awarding bodies – Lantra and City & Guilds (NPTC).
Open courses for individuals to join are also offered at our Allscott (Telford) Training Centre, Most courses lead to Lantra Awards or NPTC qualifications; a small number of niche courses where the instructor is an experienced groundsman who is also Lantra Awards or NPTC registered, offer Pitchcare certification.
Whether your staff are involved with preparing and maintaining sports turf, operating ground care machinery and equipment or require a safe use of pesticides qualification, we have the course to suit them.
For more information on our online courses click here
The Course Manual at just £30 is available for purchase separately.
Here are our upcoming open courses:
PA1/ PA6A - Thursday 17th/ Friday 18th October, Allscott Telford TF6 5DY