A fast, safe and convenient method of applying TriCure wetter through hose-end applicators. The pellets are designed to dissolve quickly in order to provide an accurate dose – sufficient to effectively treat and prevent hydrophobic soils.
Each pellet consists of 75% TriCure AD and can be used as either a stand alone treatment or as a supplement to regular water management programmes.
Many alternative pellets take a long time to dissolve – resulting in low rates of wetter being actually applied.
As TriCure AD Pellets contain a high proportion of active ingredient and dissolve rapidly, Turf Managers can be confident of optimum treatment results.
TriCure AD and TriCure AD Pellets are non-phytotoxic and will not burn or discolour turf.
|Use||Application Times per 100 m²|
|Time taken for 1 pellet to dissolve fully||To give Full Rate application |
(10 litres/ha) Apply For
|To give Low Rate application* |
(3 litres/ha) Apply For
|6 minutes||3 minutes 20 seconds||1 minutes 40 seconds|
|8 minutes||4 minutes 27 seconds||2 minutes 13 seconds|
|10 minutes||5 minutes 33 seconds||2 minutes 47 seconds|
The rate at which TriCure AD Pellets dissolve is determined by (1) Water Pressure (2) Flow Rate and (3) Water Temperature. To ensure correct dosage, carry out a calibration by recording the time taken for one pellet to fully dissolve.
Then use the table below to determine the correct dosage per 100 sq m.
E.G. – Pellet takes 10 minutes to dissolve.
Thus 5 minutes 33 seconds of application per 100 sq.m gives full rate application (approx. 10 L/ha).
2 minutes 47 seconds of application per 100 sq.m gives low rate application (approx. 5 L/ha).
Full rate (10 L/ha) will provide activity for up to 4 weeks.
Low rate (5 L/ha) will provide activity for around 2 weeks.
Please note: Longevity of activity is dependent on soil type and climatic conditions.
For further information regarding TriCure Wetting Agent Pellets, please contact our technical sales team on 01902 440250.